EP1 · Environmental Protection One

Where EP1 applies

Polygons and hectares by the Town of Halton Hills’ outlines, each polygon placed by a point inside it. 126 zone polygons fall outside every outline.

Wards: Ward 2 (83), Ward 1 (21), Ward 3 (18), Ward 4 (4).

Exceptions, holding and other markers

The markers the layer records on EP1 polygons. Their terms are written only in the by-law; each line says where.

Site-specific exception (3 polygons)

13, 55, 103Section 2.5: a number in brackets after a zone symbol refers to a site-specific exception listed in Part 13.

Holding provision (2 polygons)

H16, H6Section 2.6: where a zone symbol is followed by (H), no use other than the existing one until the (H) is removed; holding zones are detailed in Part 14.

Drawn over another polygon

10 zone polygons sit inside another polygon on the layer (the map draws one zone over another without cutting a hole). Their hectares are counted here and in the other zone; the by-law map decides which applies.

What the zone permits

The permitted uses and regulations for EP1 are set out in Part 10 of Comprehensive Zoning By-law 2010-0050 (PDF, Town of Halton Hills). HaltonHillsIQ does not paraphrase them: an exception, a holding provision or a later amendment can change what applies to one lot. The Town of Halton Hills’ Compliance Memo Request is the Town of Halton Hills’ own answer for a property. The interactive zoning map shows the zone on a single lot.