LDR1-2(MN) · Low Density Residential One

Where LDR1-2(MN) applies

Polygons and hectares by the Town of Halton Hills’ outlines, each polygon placed by a point inside it. 26 zone polygons fall outside every outline.

Wards: Ward 1 (18), Ward 3 (7), Ward 4 (1).

Exceptions, holding and other markers

The markers the layer records on LDR1-2(MN) polygons. Their terms are written only in the by-law; each line says where.

Site-specific exception (3 polygons)

25, 25-A, 55Section 2.5: a number in brackets after a zone symbol refers to a site-specific exception listed in Part 13.

Holding provision (1 polygons)

H1Section 2.6: where a zone symbol is followed by (H), no use other than the existing one until the (H) is removed; holding zones are detailed in Part 14.

What the zone permits

The permitted uses and regulations for LDR1-2(MN) are set out in Part 6 of Comprehensive Zoning By-law 2010-0050 (PDF, Town of Halton Hills). HaltonHillsIQ does not paraphrase them: an exception, a holding provision or a later amendment can change what applies to one lot. The Town of Halton Hills’ Compliance Memo Request is the Town of Halton Hills’ own answer for a property. The interactive zoning map shows the zone on a single lot.

LDR1-2(MN) is not in Comprehensive Zoning By-law 2010-0050's Section 2.1, Zones (Comprehensive Zoning By-law 2010-0050, December 2025 office consolidation); its name here is the one the layer gives it.